Rear Camber Toe adjusters with Rotary slide bearings

[Pete M]

Newbie here be gentle

Wondered if anyone has tried using the Ireland Engineering camber toe adjusters with E32 rotary slide bearings installed in the rear trailing arms

My concern is that as the name suggests the rotary slide bearings only rotate and slide so would they accommodate the slight misalignment caused when adjusting camber toe

I've also seen a video posted on the forum of the Pitman Arm, toe link in action showing that as the trailing arm moves the bushes allow slight laterally movement, would the adjusters cause a binding effect again when slightly misaligned

Many thanks

Peter

[mooseheadm5]

They work fine together. The E34 M5 had slotted toe adjusters built into the rear subframe from the factory, and also used the bearings instead of the bushings. I have this setup on my wagon now.

[Pete M]

mooseheadm5

Thanks for the instant and confident reply

I knew the M5 used the bearings but wasn't aware of the slotted adjusters

Many thanks

Peter

[Frybrid 524td]

I have a set of rotary bearings with some mangled boots if anyone is interested. They are unused but you'll need to get boots off of something else.

[mooseheadm5]

I'll take those!