Page 2 of 2

Re: 533i v3: Turbo LS

Posted: Aug 14, 2023 6:24 PM
by mitch5
tschultz wrote: Aug 10, 2023 11:37 AM Nice updates, I am sure the new paint is making you excited to use the car more. This makes me want to paint my car sooner than later!
The paint does give me renewed motivation!If I were to paint again I think I would've done all prep and detrim and just paid Maaco for this level car. I know a few pro painters but it would have cost $800 to get a booth and they weren’t stoked about single stage. When I painted it I had more time than money so I attempted myself. The result was 2 days of buffing to get the orange peel under control.

Re: 533i v3: Turbo LS

Posted: Aug 14, 2023 6:27 PM
by mitch5
Started tuning the car but even doing it at midnight when Phoenix is only 90 degrees the car is unbearable after 30 minutes to the shear amount of heat coming off the motor. I need to put some insulation in.

On the plus side the car drove further in a half hour than it has been pushed around in the last 5 years.

Re: 533i v3: Turbo LS

Posted: Aug 15, 2023 3:15 PM
by turbodan
mitch5 wrote: Aug 04, 2023 3:53 PM Bought a new Chinese holset center section(had a rock ruin the old compressor), flow testing all the clogged injectors(1 year old fuel) and started tuning. After driving a westy vanagon for 2 years, this thing feels like a rocket ship.
A rock would do it. Air filter on hiatus?

Re: 533i v3: Turbo LS

Posted: Aug 17, 2023 1:56 AM
by mitch5
Yup although I ran the compressor totally fine with the last setup by blending the corresponding impeller to match. What did it in was the turbine blade fell apart and destroyed the bearings etc. That may of also been a rock.

No filter yet but I did epoxy some aluminum honey comb into the housing intake. It won’t let anything smaller than an 1/8 in I think? that is a sort of temporary solution until I decide to spend the time on a proper filter. I swear I had a silicone elbow but can’t find it.

Re: 533i v3: Turbo LS

Posted: Sep 06, 2023 3:00 PM
by mitch5
Well I went to finally move the car from my brothers to my place under its own power and it caught on fire.

I caught it quick,pulled into a lot and had water ready douse it. Turns out my steering box is pissing fluid right onto the headers. Now I must remove the headers and get to the box to see what’s really leaking

Re: 533i v3: Turbo LS

Posted: Sep 08, 2023 2:54 PM
by BDKawey
mitch5 wrote: Sep 06, 2023 3:00 PM Well I went to finally move the car from my brothers to my place under its own power and it caught on fire.

I caught it quick,pulled into a lot and had water ready douse it. Turns out my steering box is pissing fluid right onto the headers. Now I must remove the headers and get to the box to see what’s really leaking
years ago on my 5.0 swapped car, my PS line leaked and soaked the heat shielding I had around the hose. after getting back from a short trip back from the gas station I popped the hood for some smoke, sleeve was on fire. I ran to get an extinguisher and while putting it out the fire jumped the starter solenoid wires and it tried to start and run me over. fortunately it hit a pile of tires and remained attempting to start until I scrambled to unhook the battery.

v8 and power steering fires. yay

Re: 533i v3: Turbo LS

Posted: Sep 12, 2023 4:57 PM
by mitch5
Lol, I almost spit my drink out reading your experience. I guess things can always get worse.

I wish there was a simple replacement for ditching the box but the few people I have seen do rack conversions have made it seem pretty involved.